Acer Aspire one AOD150 Jasper

user

Replacing the Bluetooth Module

Fri, 12 Nov 2010 07:47:07 | Acer Aspire one AOD150

How To Reset Your Windows Password

Connect the Bluetooth cable to the Bluetooth 2. Place the Bluetooth Module in the Lower Cover as
shown.

1. Place the USB Board in the Lower Cover as shown. Ensure that the WLAN switch (red callout) is correctly placed in the spacer (green callout).

: 2. Replace the single securing screw. 3. Connect the USB cable to the USB Board.

4. Secure the cable in the connector with the adhesive 5. Connect the USB cable to the Mainboard. strip.

: Place the LCD Module on the Lower Cover and secure it in place with the two screws.

: 4. Run the Camera cable along the Lower Cover using all available cable clips.

5. Connect the Camera cable to the Mainboard. 6. Run the Antenna cables along the Lower Cover using all available cable clips.

: 7. Pass the Antenna cables through the Lower Cover and them in place with an adhesive strip.

8. The Lower Cover appears as follows when all the LCD cables are correctly placed.

1. Insert the FFC through the Upper Cover as shown, 2. Secure the FFC in place by closing the FFC latch. and connect it to the TouchPad Board.

3. Insert the TouchPad Bracket bottom edge first as 4. Rotate the bracket on to the Upper Cover, ensuring shown. Ensure that the three securing clips are that the two locating pins are properly located.

engaged.

5. Slide the bracket in the direction of the arrow to 6. Replace the single securing screw. engage the final securing pin.

Average user rating: 5 stars out of 1 votes

Acer Laptop Repair Guides