Nil tz j
3. Remove the four screw securing the Subwoofer to the Lower Cover.
NOTE: The screws securing the Subwoofer in place are cushioned by rubber washers. Ensure that the washers are replaced before replacing the screws.
|
Step |
Size |
Quantity |
Screw Type | |
|
Subwoofer |
M2*3 |
4 | ||
- See "Removing the Subwoofer" on page 103.
- Remove the six screws (three each side) securing the Hinge Supports to the Lower Cover.
|
Step |
Size |
Quantity |
Screw Type |
|
Hinge Supports |
M2.5*4 |
6 |
* |
- 3. Lift the Hinge Supports clear of the Lower Cover.
- See "Removing the Mainboard" on page 99.
- Remove the six screws securing the Speaker Module in place.
NOTE: The screws securing the Speaker Module in place are cushioned by rubber washers. Ensure that the washers are replaced before replacing the screws.
|
Step |
Size |
Quantity |
Screw Type | |
|
Speaker Module |
M2*3 |
6 | ||
- See "Removing the Mainboard" on page 99.
- Disconnect the fan cable from the Mainboard.
- Lift the Thermal Module clear of the Mainboard.
- Lift the Thermal Module clear of the Mainboard.
- See "Removing the Thermal Module" on page 107.
- Remove the two screws (in reverse numerical order from 2 to 1) securing the Graphics Card Heatsink to the Mainboard.
|
Step |
Size |
Quantity |
Screw Type |
|
Graphics Card Heatsink |
M2.5*6.5 |
2 |
- 3. Lift the heatsink away from the Graphics Card as shown.
- See "Removing the Graphics Card Heatsink" on page 108.
- Remove the single screw securing the Graphics Card to the Mainboard.
|
Step |
Size |
Quantity |
Screw Type |
|
Graphics Card |
M2.5*6.5 |
1 |
- 3. Remove the Graphics Card from the Mainboard connector.
- See "Removing the Thermal Module" on page 107.
- Turn the securing screw 180° to release the CPU from the socket.
3. Remove the CPU from the socket as shown.
IMPORTANT: The pins on the underside of the CPU are very delicate. If they are damaged, the CPU may malfunction. Place the CPU on a clean, dry surface when it is not installed.
Post a comment