Replacing the TouchPad Board
IMPORTANT: The TouchPad is supplied as part of the Upper Cover. If the TouchPad is defective, replace the entire Upper Cover.
1. Insert the board into the Upper Cover. Take care to align the mounting pins with the holes on the board.
2. Remove the two screws securing the TouchPad Board in place.
|
Step |
Size |
Quantity |
Screw Type | ||
|
Finger Print Reader |
M2*3 |
2 |
* | ||
- 3. Insert the FFC through the slot in the Upper Cover and adhere as shown.
- Connect the Mainboard FFC to the TouchPad Board and close the locking latch.
- Connect the Mainboard FFC to the TouchPad Board and close the locking latch.
- 5. Connect the TouchPad FFC to the TouchPad Board and close the locking latch.
- 6. Connect the TouchPad FFC to the TouchPad and close the locking latch.
1. Insert the tabs in the bottom of the fingerprint reader bracket into the upper cover and rotate the bracket into place as shown.
- 2. Insert the two screws to secure the bracket to the Upper Cover.
|
Step |
Size |
Quantity |
Screw Type |
|
Finger Print Reader Bracket |
M2*3 |
2 |
* |
Post a comment