Replacing the Thermal Module
WARNING:To prevent damage to the Thermal Module or the CPU, hold the Thermal Module by both ends at the same time.
1. Align and place the Thermal Module in the on the 2. Replace the two securing screws (red) and tighten mainboard as shown. the four captive screws (blue) found on the
Thermal Module.
3. Connect fan cable to the mainboard
- as shown.
1. Ensure that the Mainboard is face up. Place the Mainboard in the chassis, left hand rear edge first.
2. While holding the left side of the Lower Base, lower and pivot the mainboard in to the base.
3. Ensure the screw sockets are aligned. Replace the three securing screws as shown.
NOTE: Make sure the I/O ports are positioned correctly through the lower cover, and the screw sockets are visible through the mainboard.
4. Reconnect the subwoofer cable to the mainboard.
IMPORTANT:Ensure that the cable passes through the mainboard, as shown, and is inserted into the retaining clip to avoid trapping when the upper case is replaced.
- 5. Replace the RJ-11 cable in the retaining clip on the mainboard and stick it in place using the adhesive strip.
1. Position the module over the aligning pins and 2. Replace the bluetooth cable as shown. insert in place.
- 3. Replace the single screw to secure the board.
Average user rating: 5 stars out of 1 votes
Post a comment